cancel
Showing results for 
Search instead for 
Did you mean: 

Link Between Tolerance Settings In Table T169G and the System Messages They Generate When Tolerances are Exceeded

Former Member
0 Kudos

I am trying to view my company’s tolerance settings relating
to MIGO (e.g.- AN, PE, DQ, etc.) per review of table T169G and see how variances
over established tolerances will be handled (e.g.- as a warning or error) per
review of settings in table T100S. Where can I find information regarding the relationship between the tolerance settings in T169G and the
error message numbers they produce? Specifically, I was Googling for
information on tolerance setting PE and found in numerous places that the corresponding
error message for variances over the tolerance is message No. 207. However,
when I view our table T100S as well as Google on this message No. I find that message
No. 207 is defined as “Line item & has not yet been entered”. This hardly
sounds like a PE error message!!!

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

I am trying to view my company’s tolerance settings relating
to MIRO (e.g.- AN, PE, DQ, etc.) per review of table T169G and see how variances
over established tolerances will be handled (e.g.- as a warning or error) per
review of settings in table T100S. Where can I find information regarding the relationship between the tolerance settings in T169G and the
error message numbers they produce? Specifically, I was Googling for
information on tolerance setting PE and found in numerous places that the corresponding
error message for variances over the tolerance is message No. 207. However,
when I view our table T100S as well as Google on this message No. I find that message
No. 207 is defined as “Line item & has not yet been entered”. This hardly
sounds like a PE error message!!!