Impact on BCS when upgrading SAP BI 7.0 to 7.3

[former_member351149]

Dear All,

BCS is installed in our SAP BI 7.0. Now we are upgrading SAP BI 7.0 to SAP BI 7.3. Could anyone please suggest, what are prerequisites need to be taken care. Is any patch level need to be install after upgrading?

Suggestions will be very helpful.

Regards,

Abhishek Jain

[former_member209032]

Hi Abishek,

   As far as i know there is no specific prerequisites for BCS. Check in UCMON and UCWB before and after upgrade. As a result of upgrade some of the objects used in BCS cube might become inactive. Make sure that all objects are active after upgrade. Also what is the version of SEM-BW component in 7.0? Direct upgrade of SEM 4.0 to SEM 6.34 is not possible.

Regards,

Raghu.

[former_member351149]

Dear Raghavendra,

Currently SEM 600 available in BI 7.01. As software downloaded from Solution Manager for 7.31, SEM BCS 736 downloaded. We have upgraded Dev system and it was done fine. So wanted to make sure that while upgrading in QAS and Prod, there wont be any impact in the existing reports for BCS.

If anything comes up from your side to taken care then please share.

Regards,

Abhishek Jain