Reverse engineering on a synchronized model

[Former Member]

Hi everyone,

I did the reverse engineering of a schema from an Oracle DBMS and then I put in the repository. I could make changes to the model and save them in the repository, but, at one point, I had to do the reverse engineering of the model again and, after that, the model missed the references to the repository not allowing comparison between models and I couldn't do more any check in the repository.

I would like to know if I am doing something wrong or if this is a PowerDesigner normal behaviour. I am using PD 16.5.

Thanks in advance.

[former_member200945]

If you check out the model and compare with the local one, can you get right result?

Are you on 16.5 base release?

[Former Member]

I've tried this, but it happened the same thing: I check out the model, but when I merge the reversed model with the checked-out model, this one losts the reference to the repository. Here, we are using 16.5 base release with SP02 (16.5.2.4144 PL1).