on 06-12-2015 4:24 PM
Hi There,
My doubt is if the hit ratio is low though there are no swaps what should be done in this case.
Please answer to this question in detail if possible.
Best regards,
Bhushan
Hi Bhushan,
You need to check the parameter values and compare it with the swaps which you can get from the history.
paramters to specific buffer can be seen by clickng the parameter button.
If the system is started the hit ratio would be comparitevly less initially until the datas are load to buffer.
Would be good if you can share the ST02 screen shot.
http://www.sap-perf.ca/run-sap-st02-memory-monitor/
Regards
Nikhil
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Have you tried lowering the value of that parameter?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
94 | |
11 | |
11 | |
10 | |
9 | |
8 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.