on 07-01-2015 10:30 AM
Hi,
I am facing a strange issue here.Currently when I check in loc table in SE16 I find that with location type 1001 only the value 1200 exist.There is no entry for 1003 ( i.e shipping point) in the loc table.Just to note that both plant and shipping point have values 1200.
Now using CFM1 when I enter shipping point 1200 and do the CIFing I get the below enclosed error message in CFM3 due to which I am unable to proceed ahead.Can someone assist me here.
Hi Dipak,
Your screencut is too small to be seen.
But going by your explanation, perhaps you are getting the error 'Location 1200 already exists...'
If you are not implementing the CIF BADi for differentiating the Plant/ShPt with same names in ERP(refer SAP Note 1355784), you will run into this error.
BR
narender
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
9 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.