cancel
Showing results for 
Search instead for 
Did you mean: 

RFC check in system landscape error

Former Member
0 Kudos

Dears,

I am facing the issue that during RFC check in system landscape creation for and existing sender/receiver systems i get the below messages:

error in central system to sender RFC

* Settings for RFC destination MBT_XXX_YYY_000_00_0004_MBT have been changed.

error in control system to sender RFC

* Settings for RFC destination MBT_XXX_YYY_000_00_0004_MBT have been changed.

error in sender system to control RFC

* Settings for RFC destination MBT_XXX_YYY_000_00_0004_MBT have been changed.

error in sender system to central RFC

* Settings for RFC destination MBT_XXX_XXX_000_00_0016_MBT have been changed.

error in sender system to control RFC

* Settings for RFC destination MBT_XXX_XXX_000_00_0016_MBT have been changed.


when i go to tcode SM59 and do authorization check for all above RFCs in all systems they works fine. also in system landscape for local RFC destination and remote RFC destination all green, But landscape status is red.


Thanks.



Accepted Solutions (0)

Answers (3)

Answers (3)

Former Member
0 Kudos

thanks for your support, it was authorization issue.

0 Kudos

Hi Jafar,

Could you please elaborate on the resolution? We are facing the same issue.

Thanks,

Bala

Former Member
0 Kudos

Dear,

I've create new RFCs with new users with the same authorization, but it give error when I am trying assign the logical system for the source.

Internal error 0 while calling CNV_TDMS_08_GET_REMOTE_LOGSYS


regards,

rajesh_kumar2
Active Participant
0 Kudos

This needs to be checked in the system.

Raise a message in the component ca-tdm-frm-pcl.

rajesh_kumar2
Active Participant
0 Kudos

Dear Jafar,

It seems you are trying to re-use a system landscape which may have been created before the upgrade of DMIS/ DMIS_CNT patch in your system .

Can you please check and confirm.

Also what the SP release of your DMIS in your TDMS landscape.

Please make sure that all the relevant mandatory notes have been applied from the composite notes -

1713981

1741455

Thanks,

Rajesh

Former Member
0 Kudos

Dear Rajesh,

yes I am trying to re-use landscape, but with the same system level. today we create new landscape for shell creation with the same sender and it status is green, also it use RFC MBT_XXX_XXX_000_00_0016_MBT.

DMIS2011_1_7310006SAPK-11606INDMISDMIS 2011_1

regards,

rajesh_kumar2
Active Participant
0 Kudos

Okie..

So the issue was resolved after creating a new system landscape ?

For SP06, I think there were some corrections related to synchronization of RFC destinations.

I hope you may have already applied them from the composite notes mentioned in my last reply.

Thanks,

Rajesh