on 11-16-2015 2:59 AM
Hi all,
When I call transaction SQVI, it messages 'Convert first'.
Message no. AQ898
Before you work with queries, functional areas or user groups in this query area, you must convert the objects.
Get your system administrator to convert the objects. The ABAP Query Release Information for Release 4.0A describes how to convert these objects. Also read Note 92124.
Thanks
Kical
Hello,
As for the issue, you can run report RSAQUM40 with "Set release flag" and check again.
The answer is well-documented in SAP Note 92124.
Regards,
David
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear
Hope the query was created using transaction SQ01 which was moved through transport request.
Few queries are user specific.Kindly check that toO.
Kindly check below sap note also.
325829 SAP query: Message AQ898 after new installation
SAP Note:92124 clearly says:
Symptom
After a release upgrade from a Release 3.X to Release 4.y, you cannot maintain any query objects (queries, user groups, InfoSets, functional areas). Queries cannot be executed. In each case, the system generates a message:
AQ898 ("Convert first").
This error message occurs if a new installation of an R/3 system was made on the basis of a Release 4.y.This error message may also occur if an IDES system was reinstalled.
For more information about this, see SAP Note 109094 as well.
Hope this may help you little bit.
Regards,
Pardhu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.