Stock posting opposite direction in QA11

[Former Member]

Hello Experts,

During QA11 I am selecting(batch status) as unrestricted but posting in restricted. If I do restricted then its going unrestricted.

Note : If I maintain batch in classification then the problem occur. If I remove classification then its works as expected.

And one more problem is transaction code reflects as MSC2N. QA11 Should have been reflected in material document.

Please this is bit urgent and I have tried to debug several ways but no clue.

I am expecting your earliest response.

Regards,

A Vadamalai.

[rupesh_brahmankar3]

Hello,

Please implement OSS note 1935699 - QA11: Stock inconsistency after status change in batch stock

and implement the note 1930161 to solve this issue.

Best Regards,

R.Brahmankar

[Former Member]

Thanks Brahmankar.

If I do partial quantity then its fine and if I do full quantity then the stock is gone to opposite. What could be the cause?

And one more problem is transaction code reflects as MSC2N. QA11 Should have been reflected in material document.

Please..

Thanks,

A vadamalai.

[rupesh_brahmankar3]

Hello,

Please test the same scenario after implementing the OSS notes.

Also are using the batch characteristic valuation for  standard characteristic LOBM_ZUSTD Status of the batch?

Regards,

R.Brahmankar

[Former Member]

Hi,

Still I have an confusion this problem is only for a plant. rest of the plant working fine either partial or full.

Please advise.

Regards,

A Vadamalai.

[rupesh_brahmankar3]

Hello,

Are you using standard characteristic LOBM_ZUSTD ?

Could you please share screen shot of UD code QS51?

Status change to "Unrestricted" due to UD code

Status change to "Restricted" due to UD code.

Check OMCT for plant with batch status management.

This could be due to if batch status management is active for the corresponding plant and if the batch is assigned to the inspection lot when the usage decision is being made and the status of the batch is restricted.

Best Regards,

R.Brahmankar

[Former Member]

Hi Brahmankar,

Thanks a lot for your immediate response. Please find more

details below.

No we are not using standard batch characteristics. In MSC3N ,we have

batch status box with radio button for Unrestricted and restricted use.

The similar box for status change appears during UD and statuses in MSC3N are in sync with what we enter during usage decision.

2. We are doing stock posting without UD code with

restriction imposed through enhancement that stock can not be posted to Unrestricted

use without UD code. It can be posted to restricted use only.

Here If we do partial posting to restricted use then Batch

status (in MSC3N) is in sync with Stock (in MMBE). However if post full quantity

to restricted use though Batch status (in MSC3N) shows restricted, stock

appears in Unrestricted use. Stock should have been in restricted use.

3. Batch status is active in OMCT configuration

Awaiting for your reply

Thanks,

A Vadamalai

[Former Member]

Hi Brahmankar,

Can you please advise me.

Regards,

A Vadamalai.

[rupesh_brahmankar3]

Hello,

Batch status is active in OMCT configuration for all the plants?

What the enhancement do you have?

Best Regards,

R.Brahmankar