on 11-26-2015 11:44 AM
Hi,
I have problem with ZEBRA Printer GK420t.
I'm trying to print label created in Smartform.
On print I get strings like:
^FS019 ,47^... ^FS
^FS019 ... ^FS
What should I change in configuration^of printer (or smartform) ?
My printer is:
YZB200 Zebra Label printer 203dpi.
regards,
Michal
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Michal,
do you know this guide? I think you need to start way earlier to solve your problem. It isn't the same kind of printing using Locl or a zebra-device type.
So have a look into this guide and follow the instruction. I'm pretty sure you can solve your problem. It is all described in a good and understandable way.
~Florian
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Michal,
YZB200 must be a device type from Zebra company, to be used only in conjunction with an ABAP-based printer driver from Zebra (see note1173046, it does mention your printer ).
I assume you have installed the Zebra ABAP driver and it works ...
To find our whether printing on that printer from SAP works in principle, you might do a test with SAP device type LZEB2. It uses a SAP driver which is older and has less capabilities than the Zebra driver but should work on a basic level.
Regards,
Alex
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Where I try to print preview it's ok. I'm testing two the same printers.
First I pług into my PC via USB and set in Windows as a default printer. Then, in sap I choose LOC printer. The print of my smartform is OK.
Second printer is connected to our company network by wifi. It's added and configured in SAP in SPAD tcode. But it prints only strings without any tables and graphics .
I tried set yzb200 and lzeb2 device typem.
So you can print correctly with locally PC-connected Zebra printer using Zebra device type YZB200 ?
(so your LOCL or whatever printer definition in SPAD uses YZB200, not SAPWIN/SWINCF, correct?)
If yes, then the problem lies outside of SAP/Smart Forms, must be related to the connectivity of that other printer.
The very first command a ZPL driver sends in the print data is ^XA (and the last one is ^XZ )
Maybe, if somehow a part of this 1st command gets lost along the way, this printer will print out the following ZPL commands as text?
Well, then you are printing not via mentioned Zebra driver for SAP but with a Windows printer driver in the LOCL case, you probably use SWINCF/SAPWIN/SWIN there...
If LOCL printing with YZB200 or LZB200 does not work, and your printer prints the ZPL commands instead of interpreting them, your printer obviously does not "understand" this ZPL.
You should contact someone from Zebra or the printer reseller in that case... There is nothing to do on the SAP side.
User | Count |
---|---|
80 | |
24 | |
11 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.