How coverage profile affects MRP Exception message?

[former_member457550]

I am getting 30 Exception message in MD04 after setting coverage profile for given material. If i remove coverage profile from Material Master MD04 did not display exception message.

Thank you in advance.

Your help is appreciated.

[Caetano]

Hello

Do you understand the logic behind the coverage profile? Basically, it created a dynamic safety stock, so an exception message should be triggered when the available quantity is below this safety stock.

See more details on thread Dynamic Safety Stock Calculation | SCN

BR
Caetano

[former_member457550]

I know about it. But can you please help me in identifying safety stock and tell me why 30 is coming over there. I had tried to calculate safety stock and synchronize it with MD04 but failed to calculate.

Thanks,

Rushabh Shah

[Caetano]

Hello

Check my answer and the notes referred on the thread from my previous reply.

BR
Caetano

[former_member457550]

Hello Caetano,

Thank you for your reply.

But in my case that calculation is not fitting properly. If you want i can share snapshot of coverage profile config and MD04,

'

Regards,

Rushabh Shah