on 05-25-2016 9:22 PM
Folks,
We have Auto TO set up for posting changes.
So if we did 343 or 344; the corresponding TO is created and confirmed.
All works good; till
A.) We have blocked stock say two units (same batch) in two different storage bins for a storage type say ACR.
Now we create a PCN for single unit (instead of two; in which case it works good);
It appears that the system cannot 'locate' the source storage bin; since it has a 'choice' of two bins for the same batch.
This is creating issues at our end.
If you go to LU04; you do see a corresponding entry and then create; confirm a TO.
SAP documentation says to do manually; or that was my understanding.
Have gone through note # 566090 (seems old for the current release we are in.).
What are the options in taking care of these scenarios?
Thanks.
Please check if it's due to quant merging issue and if so check out OSS note 1004984.
Hope this helps~
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
I don't think that a custom solution could be so smart that it can replace a user decision.
This might be possible in this single case where the entire quantity is still present and just stored in several bins. But how could a program ever know which quant has to be updated if it is just a partial quantity?
User | Count |
---|---|
95 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.