on 05-24-2007 9:44 PM
Hello All,
In Cliam Recon report ( RPCLMSU0 ), we are not able to select the ALV type from the ALV selection field in the report selection screen.
We are in ECC 5.0.
Thanks for any responses.
Chakri.
The same thing happens for us, and we are on ECC 6.0. However, you can run the program without selecting anything for that field. Once you are in the report, go to the top menu and choose "Settings -> Layout -> Choose...". This will give you a pop-up with selections. You can choose All, Global, or User-specific for the Layout Setting and then choose a layout from the table below. I hope this helps.
Actually, it looks like there might be a coding error in the program. The same form is used for the value request on that field as is used to check whether an entered variant exists. That form doesn't fill anything in if the field is initial, it just looks to see if something that was entered already exists. If you look at the source code you will see that the same form is used for "AT SELECTION-SCREEN ON VALUE-REQUEST FOR sv_alvar" as is used for "AT SELECTION-SCREEN". You may want to consider opening a note with SAP about this.
- April King
Message was edited by:
April King
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
94 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.