cancel
Showing results for 
Search instead for 
Did you mean: 

To pick files from multiple directory in FILE ADAPTER

Former Member
0 Kudos

Hi all,

Is their any settings or adapter configuration parameters to be used to pick the files from multiple directory .

Accepted Solutions (1)

Accepted Solutions (1)

santhosh_kumarv
Active Contributor
0 Kudos

Hi Nandan,

U must use the option Advanced Selection For source File option in the Sender File Adapter.

Note that your Transport protocol should be NFS...

Have a look at my Wiki...<a href="https://wiki.sdn.sap.com/wiki/display/XI/SingleSenderFileCC4MultipleDirectories">Single Sender File CC 4 Multiple Directories</a>

Regards

San

Answers (5)

Answers (5)

Former Member
0 Kudos

GOOD answers

Former Member
0 Kudos

In CC config

Select Advance selection for source file.

In the table mention different directory and file name mask( exclusion mask if required) for that specific directory.

Regards,

Alok.

Former Member
0 Kudos

Nandan,

Also, see my reply in below thread

Regards,

Sreenivas

Former Member
0 Kudos

Hi,

You can only specify one directory on the communication channel. The advance selection allows the selection of different files within this directory.

Therefore you will need a communication channel for each directory you wish to pull files from.

(Just looked at the blog and see it is possible after all - I'm on the wrong SP)

Kind regards

Colin.

Message was edited by:

Colin Bickell

Former Member
0 Kudos

Hi Nandan,

Use "advanced selection for file sources" to process multiple files with one communication channel and u can also exclude the unwanted files.

Have a look at this blog:

/people/mickael.huchet/blog/2006/09/18/xipi-how-to-exclude-files-in-a-sender-file-adapter

Regards,

Sreenivas