cancel
Showing results for 
Search instead for 
Did you mean: 

Change run failing

Former Member
0 Kudos

Hi,

I'm scheduling one change run for one of the characteristics and its running for around 6000 seconds and failing with the following error message.

Termination of change to the hierarchies/attributes

Report RSDDS_AGGREGATES_MAINTAIN ended with errors

Job cancelled after system exception ERROR_MESSAGE

Has anybody faced this issue or anyone has a clue to solve this?

Thnx for your help n time

Regards

Sriram

Accepted Solutions (1)

Accepted Solutions (1)

former_member188975
Active Contributor
0 Kudos

Hi Sriram,

Can you check any details of the error...you can look in ST22.

Former Member
0 Kudos

bhanu

thnx for the quick response.. the problem was with a rollup job which had not run successfully and that was creating some locks. Now its been deleted and the change run ran sucessfully

Thnx again

sriram

Answers (1)

Answers (1)

Former Member
0 Kudos

Hi Sriram,

Termination of change to the hierarchies/attributes

Report RSDDS_AGGREGATES_MAINTAIN ended with errors

Job cancelled after system exception ERROR_MESSAGE

Sol: This issue was caused due to other parallel aggregates which are running/strucked for long time.

Kindly go to RSA1 -> Tools -> Apply Hierarchy/Attribute Changes for Reporting.

After execute screen is opened kindly check the status of your run. Through change run monitor option, you can identify parallel aggregates identified during run time. Reran all the aggregates and check the roll ups if any affected.

Now select the option with variant and provide your variant details there and execute the job. Failed job should be finished successfully.

0 Kudos

Hi,

Please follow the same instructions.

Rg,

satya.

0 Kudos

Hi,

Normally change run get failed due to BIA issues and locking issues.

Please try to check out is there any chain is running attribute change run for that characterstic.

My advise is : these are the common error which we faced, Please try to exectue after checking the dependencies.

Please try to check below mention paths:

try to read out :

BIA: Several problems related to BIA and change ru

if you are statisfied with the answer please give points.


Regards,

Satya.