on 07-08-2009 10:45 AM
Hi,
when searching for users with * in User Administration I receive a following message:
"Last search might be inaccurate". No element found
and the defaulttrace contains the following message:
LDAP:error code 11 - Administrative Limit Exceeded.
Maybe some settings from the LDAP side cause this error?
Any ideas how to fix this problem?
Regards,
Ladislav
Hi,
this error is not happening anymore.
The client probably changed some settings on the LDAP side.
Regards,
Ladislav
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Ladislav,
Assuming you are using Active Directory as your LDAP then it is limited to return only 1000 results and since JNDI doesn't support paging you get this error.
Microsoft recommends leaving this value on 1000 and not changing the LDAP policy however you can increase it by changing the MaxPageSize property on LDAP. You can find a HowTo guide [here|http://support.microsoft.com/kb/315071/]
Hope it helps,
Roy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Roy,
I haven't done that yet, unfortunately I don't have direct access to the LDAP.
I didn't mention it before, but the same error happens when indexing ume index - users from this production LDAP are not indexed.
When the portal is connected to the test LDAP they are indexed correctly.
I have asked our customer to check the MaxPageSize settings and to find out if there are any differences in configuration between the test and production LDAP systems.
Regards,
Ladislav
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.