on 02-14-2011 11:34 AM
Hi,
when i am sending idoc from ecc to pi using we19 this message shown:
IDoc 0000000000181226 was saved but cannot or should not be sent
in sm58 Trfc error status is
EDISDEF: Port SAPDSD segment defn E2WRF1M002 in ID oc type DEBMAS06 CIM ty
This scenario is working fine few days ago but from today it is not working.
Please suggest.
Regards
Mohit
Hi,
go to idx2 of your PI segment and delete the existing meta data of CREMAS idoc you are sending..
The reason for this error is due to change of the idoc structure and but not have imported the same in PI..
HTH
Rajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Make sure that the sender partner and receiver partner values corrrespond to the logical system names you have used in your partner profile in we20. Sender Partner Name should be your R/3 logical system name, and Receiver Partner Name should be the Logical System name for which you have created an Outbound Entry in We20.The Sender port and receiver port also should be the one created in We21 for XI, and SAP+"SYSID" for R3
after completing the we19 ,if you click on oubound , you got the error that IDoc saved but not pushed right,
see first check partner profile is properly configured or not for outbound IDoc type,
next check distribution model is configured or not .check port also.
every thing configured correct, then use se38 and run the program RBDMOIND.
Thanks,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
77 | |
9 | |
8 | |
7 | |
6 | |
6 | |
5 | |
5 | |
5 | |
5 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.