Storage location determination in Production order

[mallikharjunrao_thota]

Hi Friends,

I have the below problem with the issue storage location determination in the production order ,

PP Order with 2 components comming from different storage locations

Com p 1 - Sloc X - Material master MRP-2 sloc X - Work cneter PSA with Sloc X

Comp 2- sloc Y - Material master MPR-2 sloc Y -Work center PSA with Sloc X(As WC is common for both the materials )

When I create PP order with CO01 T-CODE system works good ,it picks the storage location as below in PP order

Copm 1 - Sloc X

Comp 2- Sloc Y (as required as material is maintained in Sloc Y and MPR-2 sloc is Y)

But when I create order with CO10 T-CODE I have the below result in the PP order which is not desired

Copm 1 - Sloc X

Comp 2 -Sloc X (Which should be Y as per the material master settings and the comp2 is not maiantained for Sloc X)

Please let me know if any OSS note needs to be applied for this case , I am using ECC 6.0 version.

Thanks and Regards,

Mallik.

Edited by: MALLIKHARJUN RAO THOTA on Jan 26, 2012 6:22 PM

[Caetano · Accepted solution]

Hello

The issuing storage location is determined in three steps in the production order:

o First, the issue storage location of the material to be issued

(MARC-LGPRO) is transferred to the material master from the MRP

data if it is filled.

o The system overwrites this value with the issue storage location

from the bill of material (RC29P-LGORT, STPO-LGORT) if it is

filled.

o If the operation to which the component is assigned in production

order contains a work center with supply area, the storage

location is transferred from this supply area (PVBE-LGORT).

However, this transfer is only carried out if storage location

data (MARD) is maintained for this storage location for the

material.

Note 137225 provides more details about the storage location determination.