on 06-05-2012 10:13 AM
Hello, experts.
I have a problem on setting up on Managed System Configuration for SAP HANA on SOLMAN71.
THe environment is
SAP HANA SPS04 revision 28.
Solution Manager 7.1 SR1
I have already done this 2steps "Preparation of Solution Manager", "Preparation on HANA"
and at the next step,
I have some troubles.
Under the steps Managed Systems Configuration
Technical System -> Configure System ->step 5"Enter Landscape Parameters" -> Landscape Objects
it shows
Installed on path <Not Defined>(HANA Installed Technical System)(1)
and Status is "No parameters" (see the attached file1)
Technical System -> Configure System ->step 9"Check Configuration" -> Configuration Check
Message "Managed System ...~HANADB is not configured"
"No Path found in the Installed Technical System" in detail.(see the attached file2)
---------------------
I already check following URL. and needed procedure is already done.
and
I tried input the path on Technical System.(see the attached file3,4)
but nothing changed.
Regards.
Remove (if set) diagnostic relevent product and reassign it.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello,
As per, Managed System Setup of HANA in Solution Manager 7.1 - SAP Solution Manager Setup - SCN Wiki this is a known issue and can be ignored
Regards,
Abhilash
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello,
We are also facing similar issue "No Path found in the Installed Technical System" on our HANA systems. I have followed 1745227 and retried. Still no luck. How was your issue fixed?
Thanks,
Chaitanya.V
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
as this data is retrieved from the Landscape API Cache you can switch off the cache under RCA --> Administration --> Landscape Browser --> Admin --> Landscape Configuration --> Enable.
Afterwards you should be able to enter the installation path in the check. Refresh the view. Do not forget to enable the Landscape API Cache afterwards due to performance reasons.
Background is, that the cache is for accelerating the LMDB accesses.
Best regards
Falk
Hi Kiran
when entering the WoC RCA on the left side bottom there you can find a link called Adminstration. When you expand this you will see the Landscape Browser.
Or you use the follwing link exchanging your host and port.
http://<host>:<port>/sap/bc/webdynpro/sap/diagls_landscape_browser_app?sap-language=EN
Best regards
Falk
Hi,
please refer to SAP Note 1745227 - Troubleshooting the Landscape API in SolMan 7.1, point 18.
Regards,
Tomasz
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hellow there
Refering to your image file 1.png once you click on the node Installed on the path , on the right side of
screen the absolute path would be displayed ,, there you need to make sure that it should be correct
if not then you have to manually provide them.
Best Regards
Jai Wardhan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
76 | |
9 | |
8 | |
7 | |
6 | |
5 | |
5 | |
5 | |
5 | |
5 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.