on 09-15-2014 6:21 PM
Hi,
We are using ESS/MSS on EhP7. So far we did not configure ESS Foreign Address scenario.
For new address creation, I found V_T7XSSPERFORADD to be maintained from SDN.
But for change of existing address, I cannot find a clear answer.
Can you please suggest.
Thanks
Arindam
I am unable to zero in on your exact requirement or the problem you are facing but you might find this blog useful.
Prashanth
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Siddharth,
Yes, we are using WD ABAP screens.
Please see the screenshot below
(screenshot is only for Permanent address but problem exists for other addresses too).
We face the problem for Permanent Address (infty-0006,subty-1), Permanent Emergency address ((infty-0006,subty-Z1), Secondary Emergency Address ((infty-0006,subty-Z2). Those are the three addresses we are using.
Thanks
Arindam
I guess this is standard behaviour.
The county field would be electable if you are creating a new address.
To edit an existing address , you would have to delete it and then create a new one.
I have seen this behaviour in one of the implementations.
May be Siddhart can confirm this?
Regards,
Sahir.
yes, Sahir right, Please read here http://scn.sap.com/thread/3505842 In ESS, when you create foreign address then based on selected country, specific address format is displayed. You can maintain usecase A1 or A4 for Permanent address. End user must create new record whenever different country is used. ESS & PA30 behaviour is similar in this case. Old record should get delimit and a new record must be created for Time constraint 1 subtypes. This behaviour is true for all subtypes of all infotypes.
User | Count |
---|---|
86 | |
7 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 | |
2 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.