05-11-2015 9:04 AM
Hello everyone,
I am generating ETM requirements through PS and I am able to check the requirements in the requirements list through the transaction /sapcem/pt01.
But when I double click on the requirement, I get a dump with a message as follows "The status selection profile SAPCEM1 does not exist."
Any suggestions?
Thanks & Regards
05-11-2015 8:05 PM
Hello ,
can you describe the error in details or may be with a screenshot ?
Are you trying to create a order using the Req. note or just the display is dumping ?
Regards,
Sabyasachi
05-11-2015 8:05 PM
Hello ,
can you describe the error in details or may be with a screenshot ?
Are you trying to create a order using the Req. note or just the display is dumping ?
Regards,
Sabyasachi
05-11-2015 10:26 PM
Double clicking on the outlined item to navigate to the planning table gives the dump.
05-12-2015 4:18 PM
Hi Salman ,
Please check if the status selection profile(SAPCEM1) has an entry in the (View V_TJ48 / Table TJ48 ). you can create an entry for this selection profile in this table as shown in the screenshot below.
Use tcode sm31 to create the entry .
05-13-2015 9:46 AM
It Worked.. !!! Many Thanks..
I got the planning board, but without requirements. Need to recheck configurations.
Can you explain the significance of the selection profile SAPCEM1.